[sap-basis] Current IBase component is not in an active IBase
Posted by
Admin at
|
Share this post:
|
|
0 Comments
 | Posted by BASIS GUIDE (SAP NW Technology Consultant) on May 18 at 10:22 PM |
Hi -
I was setting up a landscape for mock upgrade of our Solman 4.0 SPS 14
system to EHP1.
I have SOL as my test solman system - SP 14 which is hooked upto two BI
7.0 sandboxes in a two system landscape. I went thru the configuration
steps in IMG for setting up the system.
We are using Service Desk and I wanted to replicate the scenario. I
have managed to create the Ibase components and also activate them in
IB52. THe initial data transfer was done in DSWP to create iBase. By
this was I managed to create a Support Message and then a Change
Document. However now in the Change Document it gives me an error
for "Current IBase component is not in an active IBase".
I am using SOL_MAN_DATA_REP as my External ID. and can see the systems
and solution active in IB52/IB53.
However, during the process of implementing the following note,
"Note 903528 - Solution Manager issue management and service plan: BC
sets" - I faces BC set activation errors.
I am not sure what is causing this and we need to figure out a way to
go further.
Thanks!
RazaMahdi.
__.____._ I was setting up a landscape for mock upgrade of our Solman 4.0 SPS 14
system to EHP1.
I have SOL as my test solman system - SP 14 which is hooked upto two BI
7.0 sandboxes in a two system landscape. I went thru the configuration
steps in IMG for setting up the system.
We are using Service Desk and I wanted to replicate the scenario. I
have managed to create the Ibase components and also activate them in
IB52. THe initial data transfer was done in DSWP to create iBase. By
this was I managed to create a Support Message and then a Change
Document. However now in the Change Document it gives me an error
for "Current IBase component is not in an active IBase".
I am using SOL_MAN_DATA_REP as my External ID. and can see the systems
and solution active in IB52/IB53.
However, during the process of implementing the following note,
"Note 903528 - Solution Manager issue management and service plan: BC
sets" - I faces BC set activation errors.
I am not sure what is causing this and we need to figure out a way to
go further.
Thanks!
RazaMahdi.
Copyright © 2010 Toolbox.com and message author.
Toolbox.com 4343 N. Scottsdale Road Suite 280, Scottsdale, AZ 85251
Toolbox.com 4343 N. Scottsdale Road Suite 280, Scottsdale, AZ 85251
Related Content
In the Spotlight
White Papers
In the Spotlight
Your SAP Security is at Risk...Learn How to Stay Protected. Read the free white paper from SenSage
View this thread online
Manage group e-mails
Create an FAQ on this topic
Tell us what you think
Unsubscribe from discussion
Manage group e-mails
Create an FAQ on this topic
Tell us what you think
Unsubscribe from discussion
