Announcement:
wanna exchange links? contact me at sapchatroom@gmail.com.
Posted by
Admin at
Reply from numac on Dec 3 at 2:32 AM Hello,
I tried this, it did not work properly, but I found a way to make it work. For that thank you.
However, in this manner I just send the data from 1 counter to another, and i have to change also the counter in the IP02.
Because I have over 500 counters this was not the answer I hoped for.
I was hoping for an easy way to copy the counter in the whole from one place to another, but it's probably not possible.
Regards
John greoenendaal
| | | ---------------Original Message---------------
From: Vikas Sharma
Sent: Friday, November 29, 2013 6:50 AM
Subject: Copy Counters from a Functional Location to an Equipment
Hi,
To transfer counter from one measuring point to another (Functional location to Equipment or equipment to equipment), follow following steps
Part 1
Step 1: Run tcode IK02.
Step 2: At top left cornor, click on Additional data.
Step 3: Tick on Transfer Supported.
Step 4: Ok and Save.
Part 2
Step 1: Create new measuring point for equipment through ik01.
Step 2: Fill all the required data.
Step 3: At top let corner, click on Additional data.
Step 4: Click on "Assign Manually"
Step 5: Fill Reading transfred from and duration as per our requirment.
Step 6: Ok and Save measuring point.
All the counters would be transfered from previous measuring point to new measuring point.
NOTE: Charactersticts of previous and new measuring point should be same.
Regards..
Vikas Sharma |
| Reply to this email to post your response. __.____._ |   _.____.__ |
