Announcement:
wanna exchange links? contact me at sapchatroom@gmail.com.
Posted by
Admin at
Reply from john.louk on Dec 3 at 10:36 AM The usual reason for this happening is there is no data in the internal table.
Have you run this in debug and checked the internal table?
What is the name of the table control on the screen?
Cheers
John
| | | ---------------Original Message---------------
From: Trisha DeVrieze
Sent: Friday, November 30, 2012 12:45 PM
Subject: Table Control Loop in PAI
In PAI, I have the table control loop, with data, and it does the looping but never enters the loop. So it gets to the LOOP AT scroll_tab and goes right to the ENDLOOP. In between there is a MODULE and then a CHAIN statement with FIELDS and MODULES. The screen allows for 3 entries so it goes to LOOP AT ... ENDLOOP 3 times and moves on. Any ideas why it doesn't enter the loop? It falls into the PBO loop no problem.
PROCESS BEFORE OUTPUT.
MODULE trans_init.
LOOP AT scroll_tab WITH CONTROL tc_pers
CURSOR scroll-cursor.
MODULE lst_sys_col.
MODULE get_entry_afrud.
MODULE set_cursor.
ENDLOOP.
PROCESS AFTER INPUT.
*--------------------- Processing after entering ------------------
MODULE processing_exit AT EXIT-COMMAND.
MODULE save_ok_code.
MODULE get_cursor_line.
LOOP AT scroll_tab.
* Provide confirmation data from table
MODULE get_conf_from_table.
CHAIN.
FIELD: afru_col-selkz,
afrud-pernr,
afrud-ismnw_2.
MODULE get_aufnr_from_cmfu ON CHAIN-REQUEST.
MODULE afvgd_set.
FIELD: afrud-ismnw_2
MODULE request_ismnw ON REQUEST.
FIELD: afrud-ismnw_2
MODULE reset_vbkz ON REQUEST.
MODULE get_conf_col.
MODULE check_conf_col ON CHAIN-REQUEST.
MODULE check_conf_col_save.
ENDCHAIN.
CHAIN.
FIELD: afrud-ismnw_2
MODULE check_kum_arbeit ON CHAIN-REQUEST.
ENDCHAIN.
MODULE reset_request.
ENDLOOP. |
| Reply to this email to post your response. __.____._ |   _.____.__ |
